Ripagreen, natural weeding

Commissioning

Procedures and instructions for use

Maintenance tips

Assembling the cart

This tutorial outlines the main steps set up your cart.
When carrying out these steps, please read the operating manual available from the link below:
assembly manual

Assembling the thermal lance

This tutorial outlines the main steps to set up the thermal lance.
When carrying out these steps, please read the operating manual and the safety instructions available from the link below:
operating manual
safety instructions

Assembling the Easy Pack

Commissioning of the Easy Pack with installation of the gas bottle and connection of the thermal lance.

Use on alleyways and large surfaces

Description of use for the Easy Pack in Push mode, ideal for treating accessible and drivable large surfaces (pavements, alleyways, streets, squares...).

Use on difficult terrain

Description of use for the Easy Pack in Carry mode to treat inaccessible areas (cemeteries, plant beds, small alleyways...).

Easy Plus option: productivity in Carry mode

Make your own way forward while de-weeding thanks to the ergonomic harness of the Easy Plus option.

Mobility Pack: small surfaces and rough terrain

Designed for maximum mobility on small surfaces and rough terrain (steps, steep slopes, private gardens...).

Instructions for use

Good practices for safe use for the full range of Ripagreen products.
Role-playing risk practices.
Complete these tutorials by reading the safety instructions available from the following link:
safety instructions

Inspecting the gas pipe

Prior to operation, make sure to check that the pipe and its connections are in a good condition and free from gas leaks.

Cleaning the heat diffuser

After using, make sure you thoroughly clean debris from the heat diffuser in order to avoid performance losses due to clogging.

Checking the dual-safety pressure regulator

Every 500h or every quarter, check the pressure regulator’s safty shut-off system is in proper working order.

Cleaning the rotating connector filtre

Every 500h or every quarter, check the rotating connector filter and clean it if required using a needle or small brush.

Replacing the Piezo igniter

If the thermal lance is having trouble lighting, replace the Piezo igniter with the spare igniter available in the safeguard compartment.


"Next" "Back" "Start"


Use buttons to go on or replay